This listing is for the Hollow knight Mask and Nail !! This is my personal interpretation design of the hollow knight mask and nail. This listing is for a full set of raw unpainted prints. They will come separated so you can easily paint and glue them together to your liking. the dowel rods are also not included but can be found at any hardware store. I got mine from lowes. Super glue can be used to combine the pieces. (Make sure there is no paint on the glued parts or else it will not adhere correctly.
The nail is perfect for Hollow knight cosplay. It is 2ft 2in long and about 6in wide
The opening at the bottom of the helmet is a little smaller than the inside so here are the 2 sets of dimensions.
hole opening front to back is a little over 8.1 in and side to side is 8.25 in
inside: front to back 9 in side to side is 9.1 in
****need to know.
parts will require sanding- I start with 120 then prim with a rustolium filler primer from home depot. Then sand with 220 grit and prime again. continue this until you are happy with the finish
also you can use any spray paint or acrylic paints to paint your item.
3/8 wooden dowel rod is needed to reinforce the sword. It needs to be about 22.25in long.
CA glue is amazing to glue the pieces together. Be careful it is the best superglue you will ever use. and it will harden very fast.
Reviews
There are no reviews yet.